Search:

Type: Posts; User: Flicktitty; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    30
    Views
    11,752

    Gotcha, Thanks i'll be sure to try that out.

    Gotcha, Thanks i'll be sure to try that out.
  2. Replies
    30
    Views
    11,752

    yeah the ECM Temp sensor and the Gauge sensor are...

    yeah the ECM Temp sensor and the Gauge sensor are pretty close in reading (within 5 degrees typically) Had an issue when i replaced the alternator something with the electric fans broke so i had to...
  3. Replies
    30
    Views
    11,752

    Thaks, I'm in the Menomonee Falls,Brookfield...

    Thaks, I'm in the Menomonee Falls,Brookfield boarder off Pilgrim and Silver Spring area.

    I will have to look into the o2 setup and double check the wiring from the wideband to the ecu.



    As...
  4. Replies
    30
    Views
    11,752

    hmm that might be a bit of a stretch to pussy...

    hmm that might be a bit of a stretch to pussy foot the car down there, i'll see what i can do, otherwise i'm more than willing to compensate your time/travel.



    Correct me if i'm wrong, but say...
  5. Replies
    30
    Views
    11,752

    Wideband is new (as in like 15 minutes of run...

    Wideband is new (as in like 15 minutes of run time as of now) The Car with the new and old sensor ran the same way.
    Starts and runs at 14.5-14.9 then it riches up to
    11.4 - 11.6 @ 115F (water...
  6. Replies
    30
    Views
    11,752

    Thanks Murray.I've checked a few other things,...

    Thanks Murray.I've checked a few other things, replaced and tested stuff, car seems to run ok now, Just starts and runs around 14.7ish then dips way down into the low-mid 10's once the car gets...
  7. Replies
    30
    Views
    11,752

    No leaks from the intake manifold Vac is...

    No leaks from the intake manifold


    Vac is usually in the 18-20 Range, when the car starts to miss it starts to lower the rpm and thus lowering the vac. The place that wired the harness up...
  8. Replies
    30
    Views
    11,752

    I haven't done one yet, i will try that on...

    I haven't done one yet, i will try that on thursday.
  9. Replies
    30
    Views
    11,752

    Don't believe so. Only have a few vacuum lines ...

    Don't believe so. Only have a few vacuum lines
    Wastegate-Turbo Which is fine.
    Turbo to intake manifold - Which is fine as well.
    FPR to intake manifold - Which is newly replaced and tight
    Blow...
  10. Replies
    30
    Views
    11,752

    Still fighting a lean misfire.

    The Car: 1989 Nissan 240sx - Aristo 2JZ-GTE - AEM EMS V2 - Single turbo kit setup - FIC 750cc injectors and Rail - Aeromotive FPR - Deatschwerks DW300 fuel pump - Russell fuel filter.

    Part...
  11. Replies
    4
    Views
    2,441

    Does that mean that the rules are any less...

    Does that mean that the rules are any less strict? i remember how many more rules the track had to abide by when it went NHRA
  12. Replies
    22
    Views
    6,121

    Last i heard AMS was $150/HR to tune. not sure...

    Last i heard AMS was $150/HR to tune. not sure how accurate that is.

    The issue is where you live, There is a decent car scene in the Fox Valley area
  13. Replies
    22
    Views
    6,121

    i'd check with Murray (WhatsaDSM) on here he...

    i'd check with Murray (WhatsaDSM) on here he tunes sometimes at West Bend Dyno he could be of some help.
  14. Replies
    22
    Views
    6,121

    Sounds like a pretty cool setup, What do you need...

    Sounds like a pretty cool setup, What do you need tuned though, The engine setup looks pretty stock imo short of an intake, and an intercooler upgrade i dont see much else.

    Also if you can make...
  15. Replies
    22
    Views
    6,121

    best bet on photos is to make an account on a...

    best bet on photos is to make an account on a site like photobucket.com and do it that way, or you can usaully link them from facebook.

    I didn't mean to come off saying you didn't have it, i just...
  16. Replies
    22
    Views
    6,121

    I don't think AMS will touch is, I know they are...

    I don't think AMS will touch is, I know they are turning away EVOs,DSMs,SRTs,etc So i can't see them doing this. So i would have to say X2 on Sound Performance, only thing is if you actually did do...
  17. Nice truck in too for results.

    Nice truck in too for results.
  18. Replies
    26
    Views
    9,156

    I must say, i have a huge soft spot for the 2011...

    I must say, i have a huge soft spot for the 2011 + 5.0 Mustangs. Whats done to the car as it sits now?
  19. Replies
    34
    Views
    11,828

    on paper yes, he should be able to get around...

    on paper yes, he should be able to get around him, but this isn't a door to door road racing event. You have to get waved by (the driver has to point the rear car by) If you had a ZL1 Camaro would...
  20. Replies
    34
    Views
    11,828

    I think what Murray is saying is if the Camaro is...

    I think what Murray is saying is if the Camaro is ONLY faster from T14 to T1 and T3 to T5 There is ALOT of ground that the slower car will go around him, But in track day's like this you have to...
  21. Thread: New to me

    by Flicktitty
    Replies
    15
    Views
    4,304

    good score. Always liked those things.

    good score. Always liked those things.
  22. Not a problem, Gino does some great hydrodipping...

    Not a problem, Gino does some great hydrodipping work. Just about the only local place (Not in Chicago) that does it.
  23. Gino @ Team Gilleto in Butler, Tell him Nick &...

    Gino @ Team Gilleto in Butler, Tell him Nick & Liz sent you.

    https://www.facebook.com/TeamGileto?fref=ts
  24. Replies
    9
    Views
    4,899

    That's awesome Ron. Might have some ideas...

    That's awesome Ron. Might have some ideas floating around.
  25. this is gonna be pretty cool, looking forward to...

    this is gonna be pretty cool, looking forward to it.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4