PDA

View Full Version : Solid roller and SBC motor parts.



MY FYN 79
10-30-2004, 09:55 AM
Need to fund the new motor project, so out with the old/new parts.

Custom ground, retro style, small base circle, billet core, cast dist. gear Comp solid roller cam- 4362/4365 lobes. 236/242 @ .050 .384 .393 lobe lift 108 LSA. Installed but never ran. $250.00

Matching Comp 954 valve springs and 732 Titanium retainers. 300 miles on these. $100.00

Comp 818 solid roller lifters. Had 300 miles on them, now fully rebuilt by Comp. $250.00

Comp Hi-Tech stainless roller rockers. 300 miles on these. 7/16 stud, 1.7/1.6 split ratio designed for above cam. $250.00

4.030 SRP flattop forged pistons, Eagle cast steel 6 inch rods, Eagle cast steel 1 piece rear main 3.48 stroke crank. The pistons need some cleaning up due to scuffing, the crank needs at least a polish and possibly a .010 cut. Great for a cheap build up. Sold as a set. $500.00

1989 4 bolt 350 block. .030 over, all machine work is done, just needs a hone and its ready to go. This is the block I lost the cam in, so the cylinder bores have some scuffing. The lifter bosses were cut down for the above solid roller lifters, so a retro style roller lifter would need to be used. $200.00

Milodon 7 quart oil pan for a 1 piece rear main seal motor. Very little use. $125.00

These parts are minus shipping, and I wont ship the block. However, I could drive and meet someone within a reasonable distance.