383/377 Stroker

[Old Guy]

This is a standard bore with a 3.75 stroke crank = 377 cubic inches. Last one went out the door today BUT I have another block cleaned honed and prepped for another stroker build. These are the late model vortec blocks set up for a hyd roller cam and this one is also drill for a mechanical fuel pump if needed. 9.5-1 compression with a 64cc head. $1300 complete shortblock NO CAM. 920-901-9777

[Old Guy]

This is a standard bore with a 3.75 stroke crank = 377 cubic inches. Last one went out the door today BUT I have another block cleaned honed and prepped for another stroker build. These are the late model vortec blocks set up for a hyd roller cam and this one is also drill for a mechanical fuel pump if needed. 9.5-1 compression with a 64cc head. $1300 complete shortblock NO CAM. 920-901-9777
Small change of plans on this one. I could not get the Eagle crank kit I wanted in time so I went with a more expensive Scat 9000 lightweight crank kit with the scat rods and Speed Pro H680CP flat tops this time. These are a 10.3-1 with a 64cc head. This one is $1400 complete with windage tray, oll pump, pan, front cover and assembled BUT NO CAM. Call if your interested this one wont last long.

[Old Guy]

One other addition to this post. I have a 350 standard 4 bolt hyd. roller block just back from the machine shop. I put forged pistons in this one with good rods and had it balanced. Block is honed for the forged Probe pistons and I install the light metric rings for more power. This is a complete short block NO CAM. $900 Call. 920-901-9777