looking to borrow welder

[stenchmiester]

Like the title says I'm looking to borrow a welder I'm building a demo derby tractor and need to weld up a few things I will pay for use of welder gas and wire just in a jam and have less than 2 weeks to get done would need to borrow it for maybe 4 houra

[Ricky Bobby]

Bring blades over and ill help u weld it up have new 10lb roll and tank of gas.

[stenchmiester]

Either way ill order the blades tomorrow

[Wagonbacker9]

My flux core mig is available if you need it.

[stenchmiester]

Wagon will it weld 1/8 inch? I need it like yesterday lol if I could possibly meet up this evening o could have it back too you wed at the lastest

[stenchmiester]

i wont have a vehicle tonight but can figure something out im in oak creek so. call me or text me 414 852 2063-eric

[Wagonbacker9]

I've welded 3/8" with it, 2 passes though, and a non-structural weld (diff cover).. 1/8" is probably its butter zone. you'll just need a 20a circuit if you're going to run it hot or more than a few seconds at a time.

Text me, 262-442-2118

[Wagonbacker9]

Good luck!