PDA

View Full Version : Wtb:someone to mini tub my car.



HY35F2T
12-26-2012, 07:39 PM
Trying to get a general idea of what it's going to cost me to get my car mini tubed it's a foxbody chassis. Pm me with offers not looking to spend an arm and a leg and I can deliver the car. I'm going with coil over setup with the shocks moved inward .

awsomeears
12-26-2012, 10:29 PM
Quality usually does cost an arm and a leg.......

If no quality maybe you might give up a arm or a leg, literally ?

HY35F2T
12-27-2012, 07:29 AM
Ehh I just looked into the steps of doing this isnt to difficult I'm just gonna do it my self. Delete or close thread.

wheelsofsteel
12-27-2012, 09:41 AM
Post before and after pics

Flicktitty
12-27-2012, 02:14 PM
Post before and after pics

What he said.

jbiscuit
12-27-2012, 02:47 PM
Lol!

HY35F2T
12-27-2012, 08:34 PM
Wont be done till after snowplow season since im doing it at my work.

HY35F2T
12-27-2012, 08:35 PM
Lol!

Did i miss the joke?

juicedimpss
12-27-2012, 09:45 PM
its not too bad of a job once you get past the 20 hours of bullshit...plus the coilover stuff.

HY35F2T
12-27-2012, 10:02 PM
I have access to a plasma cutter so figured that's a lot better than using cutoff wheels lol.

juicedimpss
12-27-2012, 10:15 PM
yes,and no.

awsomeears
12-28-2012, 07:10 PM
If you want a shop to do the work the right way 1st time Clocks Off would be the place...

He sort of knows his SHIT !!!

:)

HY35F2T
12-28-2012, 09:31 PM
If you want a shop to do the work the right way 1st time Clocks Off would be the place...

He sort of knows his SHIT !!!

:)

I know ron knows his stuff ive seen cars hes worked on. Just im sure he or anyone else isnt in my budget. plus nothing like learning something new and being able to say you did the work. anyone reccomend a good coil over shock?

juicedimpss
12-28-2012, 10:29 PM
what is your budget for shocks/springs?

Russ Jerome
12-28-2012, 10:37 PM
Doing the tin work takes FOREVER the first time, lots of cardboard templates.

Russ Jerome
12-28-2012, 10:40 PM
These coilovers where from summit, pretty cheap and decent:
https://sites.google.com/site/shelbycoltrt/
You get into it I learned a few tips I could show you.

awsomeears
12-28-2012, 11:27 PM
Actually I had Ron rebuild my whole front end on my gasser and some very nice 3" stainless exhaust, picked up and dropped off and when it came down to the hours he put in and what he charged it was very reasonable.