View Full Version : Precision metal engineer needed
JC70SS
11-05-2012, 11:03 AM
I need to have a few metal pieces made. They would look something like this.
http://i559.photobucket.com/albums/ss40/jc70ss/knob.jpg
portponies
11-05-2012, 04:14 PM
Is that more or less a thumb screw?
How big is it?
SSDude
11-05-2012, 05:10 PM
These guys look to have a big selection.
http://www.reidsupply.com/products/fasteners-hardware/fasteners/screws/thumb-knurled-head-screws/?fl=4294952586
or Fastenal is at 1600 S Miller Parkway
http://www.fastenal.com/web/Search.ex?action=productSearch&searchterm=knurled+thumb+screw
Not sure they would have them in stock but they could size it for you.
JC70SS
11-05-2012, 09:36 PM
Dave thank you sir! I just need to figure out how to find out thread diameter??
SSDude
11-05-2012, 09:41 PM
You could get it sized at Fastenal or any hardware store
JC70SS
11-06-2012, 07:51 AM
Ok, I was just going to take it to ace but wanted to be lazy. Thanks again.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.