View Full Version : anybody got a pilot bearing puller
Cryptic
08-31-2004, 08:12 AM
and a relatively small one at that. the inside diameter is just under 5/8 of an inch.
(probably a 15mm ID)
I will be forever in your debt if you can loan me this tool.
give me a buzz on my cell 414-745-1713 if you can help me out so I can stop searching for this damn thing
I don't have one, but I think you can rent one from Autozone or Advanced Auto Parts.
Max 93
08-31-2004, 11:57 AM
Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.
Corvette Jabo
08-31-2004, 01:23 PM
Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.
He is right, its a mess but it works great.
Cryptic
08-31-2004, 07:45 PM
my Dad located one for me to borrow. Hopefully it will work out.
I tried the autozone one already. It was too big.
SMS 1
08-31-2004, 11:54 PM
Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.Yup, done it that way for years. Gets :thumbsup :thumbsup in my book.
whistlin six
09-01-2004, 10:06 PM
my Dad located one for me to borrow. Hopefully it will work out.
I tried the autozone one already. It was too big.
I've got a small slide hammer setup with adjustable jaws, it works
good on pilot bearings. Lemme know if you still need one, I'll bring it
home from work.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.