anybody got a pilot bearing puller

[Cryptic]

and a relatively small one at that. the inside diameter is just under 5/8 of an inch.
(probably a 15mm ID)

I will be forever in your debt if you can loan me this tool.

give me a buzz on my cell 414-745-1713 if you can help me out so I can stop searching for this damn thing

[Al]

I don't have one, but I think you can rent one from Autozone or Advanced Auto Parts.

[Max 93]

Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.

[Corvette Jabo]

Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.


He is right, its a mess but it works great.

[Cryptic]

my Dad located one for me to borrow. Hopefully it will work out.

I tried the autozone one already. It was too big.

[SMS 1]

Another way to get it out is to use a wood dowel or whatever that fits in the hole. Fill the hole with grease then tap the dowel into it with a hammer. Repeat this till it's out.Yup, done it that way for years. Gets :thumbsup :thumbsup in my book.

[whistlin six]

my Dad located one for me to borrow. Hopefully it will work out.

I tried the autozone one already. It was too big.

I've got a small slide hammer setup with adjustable jaws, it works
good on pilot bearings. Lemme know if you still need one, I'll bring it
home from work.