Trans removal for Blazer (s-10)

[Prince Valiant]

I haven't looked at it yet, but was asked, and figured I'd ask here...

Kids at the high school are apparently having a tough time removing the top 4 bolts from the bellhousing to the block...

any trick to this? Could the drop the trans mount to get a better angle? Is it just better to go at it from the top with an open end wrench?

[SLOWC5]

3ft extension and swivel sockets are what we would use, drop the trans mount like you said to get a better angle.

Jeff

[BAD LS1]

And after it's out, pound the firewall lip flat to facilitate easier instalation.


Sent from my iPhone using Tapatalk

[Ricky Bobby]

3ft extension and swivel sockets are what we would use, drop the trans mount like you said to get a better angle.

Jeffyes


And after it's out, pound the firewall lip flat to facilitate easier instalation.
and yes