s197 driver door window help

[Silver86]

the auto up feature stopped working when opening the door this week. so when you close the door there is an 1/8 in. gap between the window and molding. when i open the door the auto down works but the window wont go back up. i also noticed that when using the switch to control the window the auto up also doesnt work.

my guess... possible bad window switch?

anyone ever run into this with their stang?

[TraceDaddy]

Read about it once on another forum.

NOTICE: Make sure there are no obstructions present in the window system when carrying out this procedure.

NOTE: The door MUST be closed during this procedure (for convertibles, the top and quarter glass must be in the closed and up position), in order for the door window motor to initialize.

NOTE: The windows must be in the full open position for this procedure to operate correctly.

Press and hold the window control switch in the UP position at the second detent until the window glass stalls into the glass top run for at least 2 seconds.
Once the top run is reached, hold the window control switch in the DOWN position at the second detent until the window glass stalls at the bottom of its travel for at least 2 seconds.
Cycle the window glass an additional 5 times to set the window soft stop for the down position.
Test for correct window operation by carrying one-touch up feature.

Check this out too. Windows start on page 44.

http://www.allfordmustangs.com/techarticles/2005MustangOM.pdf

[Reverend Cooper]

mines done this. Run it allthr way up and down a couple times it relearns its linits

[Silver86]

exactly what i needed! thank you!