PonyKiller87
06-30-2010, 06:19 PM
I'm looking for a tapered reamer bit to make the tapered hole that the shaft part of a ball joint goes into.
Looks like it should be either 7 degree/ 1.5" per foot or 10 degree/ 2" per foot. Not quite sure yet, was hoping someone might have both so I could see which one fits better.
I only have 2 holes to do, one in the top of each spindle. Right now there is the smaller 1/2" ish sized hole and I need the larger 1" ish sized hole.
For only 2 holes I can't see spending the $100 on buying the bit.
Looks like it should be either 7 degree/ 1.5" per foot or 10 degree/ 2" per foot. Not quite sure yet, was hoping someone might have both so I could see which one fits better.
I only have 2 holes to do, one in the top of each spindle. Right now there is the smaller 1/2" ish sized hole and I need the larger 1" ish sized hole.
For only 2 holes I can't see spending the $100 on buying the bit.