Anyone know a good machine shop

[lotsals1]

That can put a friggen cylinder sleeve in correctly.
My yamaha gp800 waverunner had a sleeve put in --the sleeve rotated about 10 deg. and tore up the piston.
I have a new sleeve ,I just gotta have the old one taken out and the new one pressed in. ----each cyl. just unbolts so its just the cyl.
its a 2 stroke

[JC70SS]

I always had my 2 stroke stuff done at millenuim technologies in Plymouth. Maybe try contacting modmachz.

[lotsals1]

I always had my 2 stroke stuff done at millenuim technologies in Plymouth. Maybe try contacting modmachz.Is he on this board? nevermind I pm'd him
thanx

[modmachz]

Is he on this board? nevermind I pm'd him
thanx

Bring it To Me, I will See What I Can do for you?? Really If The Sleeve Was Installed Correctly with The Proper Fit Of .002 - .004 Press It Should Not Have Moved..

262-521-2250
Donny
Automotive Engine Rebuilders/AER Trailer Sales & Service..
1604 Arcadian Ave.
Waukesha, WI 53186

[jbiscuit]

I'm surprised it would move at all? Did they put locktite around the outside of the sleeve when it was inserted? Usually when installed correctly a sleeve won't budge!

[modmachz]

I'm surprised it would move at all? Did they put locktite around the outside of the sleeve when it was inserted? Usually when installed correctly a sleeve won't budge!

You DO NOT USE LOCTITE on a cylinder Like That!!! Something is not right if there is loctite anywhere in that cylinder!!!!