View Full Version : issue with my sc
Yeehaw
04-04-2010, 05:18 PM
when i start pulling 3-5 psi of boost under acceleration, my brake light will pop on for about 5-10 seconds then turn off?
Reverend Cooper
04-04-2010, 05:25 PM
check the brakes,the fluid is low due to leak or wear on the brakes,may need work or just the fluid topped off. on accel the fluid sloshes back in the master allowing the sensor to drop and the light to come on.
Yeehaw
04-04-2010, 05:36 PM
fluid is full in the brakes and the powersteering, trying to figure out if maybe a wheel speed sensor would cause this, however the ABS light does not come on
Reverend Cooper
04-04-2010, 05:37 PM
the master sensor in the master cylinder may be bad. also check the alternator and batter for proper charging.
Prince Valiant
04-04-2010, 05:40 PM
Could there be an boost leak into the vacuum booster?
Yeehaw
04-04-2010, 07:49 PM
car is hydroboost system, wonder if the sensor is bad that is a good point coop i will try to clean it up and see if it helps any
Reverend Cooper
04-04-2010, 08:24 PM
make sure the battery and brake lights arent coming on,the belt may be slipping or the alt. may be starting to go bad,i would ctart with the sensor first tho
OxmanWI
04-04-2010, 09:11 PM
Did you start a thread over on SCCoA? I have no Idea
Yeehaw
04-04-2010, 10:04 PM
Did you start a thread over on SCCoA? I have no Idea
no but me and jason found some info, the sensor below the e-brake handle can cause it or else the fluid sensor going back could cause it
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.