88Nightmare
03-01-2010, 07:07 PM
150k miles. 2 door 4x4. 2.8L automatic. Lots of money dumped into it. New parts include:
upper and lower control arms
all new ball joints
all new tie rods
new idler arm
both front wheel bearings replaced
new front CV axles
new front brake rotors, calipers, pads and lower rubber brake hoses
new brake master cylinder
new water pump
new radiator
auxiliary trans cooler
new nitrogen shocks on each corner
Aim torsion bar keys
rear 1.5" lift shackles
new driver side body parts
passenger side body parts included, just not installed yet
newer wiper motor
new washer fluid pump
new thermostat
new speedometer cable
needs: a tune up and the sway bar reinstalled. also needs an alignment. truck has no more then 100 miles driven on all those new parts. truck may also have a vacuum leak (has a high idle). Exhaust has a leak near the manifold or y-pipe, but otherwise is all stock and intact. I think the gas tank also has a hole in it (not sure, I never filled it up all the way). Would make a good V8 conversion candidate, or just a beater.
Truck isn't perfect. Still needs other work done, but is plenty driveable. Interior is so-so. Dash is solid, but the front seats are pretty worn. Driver seat is ripped. For more info, PM me or call 414-559-6460. BCM price of $800. I have all my receipts for everything I got for the truck. Totals over $2,200, literally :eek:
upper and lower control arms
all new ball joints
all new tie rods
new idler arm
both front wheel bearings replaced
new front CV axles
new front brake rotors, calipers, pads and lower rubber brake hoses
new brake master cylinder
new water pump
new radiator
auxiliary trans cooler
new nitrogen shocks on each corner
Aim torsion bar keys
rear 1.5" lift shackles
new driver side body parts
passenger side body parts included, just not installed yet
newer wiper motor
new washer fluid pump
new thermostat
new speedometer cable
needs: a tune up and the sway bar reinstalled. also needs an alignment. truck has no more then 100 miles driven on all those new parts. truck may also have a vacuum leak (has a high idle). Exhaust has a leak near the manifold or y-pipe, but otherwise is all stock and intact. I think the gas tank also has a hole in it (not sure, I never filled it up all the way). Would make a good V8 conversion candidate, or just a beater.
Truck isn't perfect. Still needs other work done, but is plenty driveable. Interior is so-so. Dash is solid, but the front seats are pretty worn. Driver seat is ripped. For more info, PM me or call 414-559-6460. BCM price of $800. I have all my receipts for everything I got for the truck. Totals over $2,200, literally :eek: