fitment issues

[Zkid14]

just bout the whisper lid and a KN filter...put it all in and now the lid wont close correctly. The latches on the box pop off with a slight nudge or bump and i cant figure out why this is, any ideas would help a lot.

thanks,
Matt

[Crawlin]

it's hard to explain on these boards. but just needs a little finese. there are grooves that the lid needs to sit in on the lower portion. once it's in there, you can clamp it down

Chris

[Zkid14]

problem solved, dam I hate bein a rookie:rolleyes:

[Syclone0044]

Originally posted by Zkid14
problem solved, dam I hate bein a rookie:rolleyes: It's OK we all had to start somewhere. Nobody came out of their mom knowing how to modify cars... 4 years ago I didn't know how to change oil and last week I didn't know how to change brakes...

[Prince Valiant]

I still make stupid mistakes with cars all the time :(

[animal]

Originally posted by Syclone0044
I didn't know how to change brakes...

So the brakes didn't last long on RA I take it?

Did you boil the fluid?

[Zkid14]

Originally posted by Syclone0044
[ Nobody came out of their mom knowing how to modify cars... [/B]

haha, yea but wouldnt that be nice

[Syclone0044]

Originally posted by animal
So the brakes didn't last long on RA I take it?

Did you boil the fluid? No they didn't. They barely lasted 4 sessions (80 minutes) with the boost set as low as possible. I was concerned about boiling the fluid so I bought the best I could justify... Motul RBF 600 DOT3/DOT4 synthetic fluid for $15 per little bottle. 595*F Dry boiling point. Probably one of the best decisions I made last week.