73MACH
09-03-2009, 09:17 PM
Ok, I have a couple of issues I'm trying to figure out. I have a new Holley 750cfm 4160 carb on top of my 351 cleveland 2v in the '73 mach 1.
Problems are as follows.....
1. Secondaries are not opening
2. Sometimes there is a severe hesitation. If you slowly get on the throttle from a stoplight, it hesitates the worst. If you get on the gas decently, it's not anywhere near as bad and quickly regains the power, but it's still there.
How do I determine which accelerator cam or accelerator pump nozzle I would need?
Any advise to get me going in the correct direction is greatly appreciated!!
Problems are as follows.....
1. Secondaries are not opening
2. Sometimes there is a severe hesitation. If you slowly get on the throttle from a stoplight, it hesitates the worst. If you get on the gas decently, it's not anywhere near as bad and quickly regains the power, but it's still there.
How do I determine which accelerator cam or accelerator pump nozzle I would need?
Any advise to get me going in the correct direction is greatly appreciated!!