freestyle alternator replacement

[lasttimearound]

ford sucks, wont warrant the alternator on a friends 06 freestyle. anyone ever change one? i have a feeling im going to be doing this very soon.

[Holeshot]

With or without rear A/C ? Book time is 2 hrs
http://alldatapro.com/alldata/PRO~V124976811~C41681~R0~OB0~P4R0H~N/0/115013665/117099832/117099963/117099965/34853741/34863246/34863337/34863338/34863579/118886198/118886199



Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.

http://alldatapro.com/alldata/PRO~V124976811~C41681~R0~OB0~P3R0H~N/0/115013665/117099832/117099963/117099965/34853741/34863246/34863337/34863338/34863579/118886198/118886200
http://alldatapro.com/alldata/PRO~V124976811~C41681~R0~OB0~P3R0H~N/0/115013665/117099832/117099963/117099965/34853741/34863246/34863337/34863338/34863579/118886198/118886201




4. Remove the 8 pin-type retainers and the right lower splash shield.




5. Disconnect the crankshaft position sensor and release the 2 wiring harness locators from the generator splash shield.
6. Remove the lower generator boot pin-type retainer, fold the boot upward and disconnect the generator electrical connector.
7. With the generator boot folded upward, position the protective cover aside and remove the generator B+ nut and terminal.

o To install, tighten to 8 Nm (71 lb-in) .

8. NOTE: The 3 generator studs and nuts may be replaced with 3 bolts (W709986-S437) to ease the installation of the generator. Remove the 3 generator nuts and stud bolts.

o To install, tighten the generator stud bolts to 8 Nm (71 lb-in) .
o To install, tighten the new generator bolts or generator nuts to 47 Nm (35 lb-ft) .

9. Remove the generator shield and the generator.
10. To install, reverse the removal procedure.

[lasttimearound]

that is awesome man! thank you that is exactly what i needed