PDA

View Full Version : Flush mount turn signals



VroomPshhTsi
06-25-2009, 12:57 PM
Anyone do this to their bikes? Sounds pretty simple, just want to make sure it's as easy as it sounds before I drill any holes into my bike. I'm just doing the front turn signals. Do you just put in the new turn signal housing? Or do you need new wires too?

stenchmiester
06-25-2009, 02:54 PM
umm if u go with led flush mounts u need some resistor i kno i did on my r6 atleast

RanJer
06-25-2009, 05:27 PM
I did them on my F2 and my 2000 R6. Simple as can be, I just put mine in the stock location. Had to drill two small holes for the mounting screws but that is covered by the lens. I used all the existing wires from the bike, and the flushmounts I bought had terminals for Male/Female appropriately already on them.

lilws6
06-26-2009, 12:45 PM
you shouldn't need to drill any holes mine fit in my 600 just like stock but flush i tinted mine as well. i got a picture of them don't have a before as i never had the stock turn signals. right above the gsxr is the turn signal nice and flush
http://i91.photobucket.com/albums/k299/lilws6/testpics1.jpg