Where can I get a bushing/bearing pressed out?

[drewbird91]

Hi all,
I'm looking to take this somewhere quick and get this bushing pushed out. Is there any place around there area where I can take this quick? I figure $10 or so.

http://photos-c.ak.fbcdn.net/photos-ak-snc1/v3841/132/67/20306695/n20306695_34963674_6631317.jpg

[That_Guy]

do you have a bench vise? its pretty easy

[Korndogg]

if you don't do it yourself. I had Borchardt's do mine like 3 years ago. As much as I hate going to them, they did it pretty quick and if I remember correctly it wasn't that much.

[LIL EVO]

I can do it for a couple bucks. Few minutes south of the Oak Creek power plant right on the lake.

[drewbird91]

I can do it for a couple bucks. Few minutes south of the Oak Creek power plant right on the lake.
Cool I will pm you and let you know. If I come down can I get a ride in lil evo?

[twicks69]

Drew, as well, I have a press at my place in Waukesha. PM me if Jason cannot help you.

[limpimpg]

not the best way, but if you have no press or vise.you can always use a propane torch and burn it out. heat it up outside in safe place where something else won't start on fire. once it stays on fire by itself take long screwdriver .so not to burn youself and will push right out. wire bush inside to clean up rust etc. use a c clamp lube new bushing and will slide right in. unless you need to bushing to size up.