Russ Jerome
03-28-2009, 12:12 PM
There is a rust free Colorado Bronco in my signature, complete and partialy disassembled along with a complete fuel injected 1988 F-150 (runs great) that I had planned on putting on e-bay in the next few weeks unless anybody on here likes the early Bronco's.
I have just under $2200 in it with the donor truck, the Bronco has everything by itself to get on the road but I hate carbs and was told by the PO the motor was getting weak. The present 302 has an aluminum intake and Holley, 3speed trans is stock but have a SM435 top loader for it (there is a E4od auto in the F-150). This year has the better Dana 44 front axle, 9" rear, suppose to have lockers in them but I have not even gotten that far, already has 4" Ranch lift and shocks, new in box Poly bushings for "C" arms....bunch of stuff Im forgeting while sitting here at work but will take a bunch of pics if anybody is interested.
If you cruise e-bay you will see these things sell for stupid money, Im talking a decent frame with title sells for over a grand alone (fiberglass body projects). This one has dings/dents but zero body panel rot less door supports, I have one side done and will have other side done as well before selling. Frame is exceptional as well (West coast all its life).
I'll post again before putting on e-bay with better pics, realy nice project that basic skills could get running/driving in short order but I am just loaded with projects right now and shouldnt have bought it (too cheap to pass up on).
414 839 2855
or PM me here
I have just under $2200 in it with the donor truck, the Bronco has everything by itself to get on the road but I hate carbs and was told by the PO the motor was getting weak. The present 302 has an aluminum intake and Holley, 3speed trans is stock but have a SM435 top loader for it (there is a E4od auto in the F-150). This year has the better Dana 44 front axle, 9" rear, suppose to have lockers in them but I have not even gotten that far, already has 4" Ranch lift and shocks, new in box Poly bushings for "C" arms....bunch of stuff Im forgeting while sitting here at work but will take a bunch of pics if anybody is interested.
If you cruise e-bay you will see these things sell for stupid money, Im talking a decent frame with title sells for over a grand alone (fiberglass body projects). This one has dings/dents but zero body panel rot less door supports, I have one side done and will have other side done as well before selling. Frame is exceptional as well (West coast all its life).
I'll post again before putting on e-bay with better pics, realy nice project that basic skills could get running/driving in short order but I am just loaded with projects right now and shouldnt have bought it (too cheap to pass up on).
414 839 2855
or PM me here