PDA

View Full Version : parting out skidoo rev 800



Trutildeathxxx
01-12-2009, 08:43 PM
2004 skidoo rev, look at my pictures, everything else is good except the frame and tunnel, brand new motor with 15 minutes of run time, long track with under 300 miles on it. everything is aftermarket. tell me what you need

sloLs1
01-12-2009, 08:52 PM
2004 skidoo rev, look at my pictures, everything else is good except the frame and tunnel, brand new motor with 15 minutes of run time, long track with under 300 miles on it. everything is aftermarket. tell me what you need

?!?!?! what happened???

Trutildeathxxx
01-12-2009, 08:58 PM
was out at little muskego breaking in the new motor and clippled an ice heave or something and twisted the front frame section and part of the tunnel

70 cutlass 442
01-12-2009, 09:27 PM
phnoe number??? gotta buddy fixing one rite now.

Trutildeathxxx
01-12-2009, 09:30 PM
phnoe number??? gotta buddy fixing one rite now.

pm ing right now

indyzmike
01-13-2009, 01:36 AM
At least you didn't hit a pier drag racing.

badass88gt
01-13-2009, 06:57 AM
Rear suspension? What is it, 136, 144, etc?

Trutildeathxxx
01-13-2009, 07:17 AM
Rear suspension? What is it, 136, 144, etc?

its a 121 with a 136 rail extension kit,

badass88gt
01-13-2009, 07:24 AM
Just curious, what did you have in mind for the skid and track?

Trutildeathxxx
01-13-2009, 10:23 AM
Just curious, what did you have in mind for the skid and track?I would like to get 750 for the track an$500 for the skid
The track only has less than 300 miles on it and 268 studs. And all the wheels were replaced last year and new hyfax this year. Track is a 1.25 rip saw. $1200 for both

PonyKiller87
01-13-2009, 11:45 AM
How much for the engine?

Trutildeathxxx
01-13-2009, 12:13 PM
How much for the engine?

$3900. Less than 15 minutes of run time. Brand new wiseco pistons, polished ports,stator, recoil, reeds, carbs, exhaust manifold, mpem ignition and after market coils included

Trutildeathxxx
01-13-2009, 10:04 PM
recently bent my flying nun and tweak the chassis on my 2004 adrenaline. I have decided to part it out. here is a detailed list of everything that is left on the sled. If there isnt something listed i may still have it, feel free to email me with any questions or for pics. trutildeathxxx@aol.com

V force reeds with manifolds and balace bottle( less than 15 minutes of run time) $150
Front bumper assembly with some metal spikes sticking out of it. $35
Red holeshot skid plate $40
Black ski doo a arm gaurds ( less than 200 miles with them on) $30
left upper a arm(red) $25
left lower a arm with ball joint $30
shocks with red skull covers ( non piggy back) $150 for the pair
skis with mounts (red) with decent shaper bar carbides $160
Hood (black) with skull air brushed in the center of it $40
Br tech red lexan side panels (a few scuff but not bad) $45 EACH
Primary clutch with extra parts $250
secondary clutch with parts $170
800 cc motor as package( with stator, carbs, reeds, recoild, exhaust manifold, mpem, aftermarket coils with wires.) $3900
motor was rebuilt and has fifteen minutes of run time on it. Has brand new wiseco pistons.
carbs $175
chaincase assembly $150
Jackshaft $125
steering post $45
1Tie rod and center rack $25
spidles( powder coated red) $40 each
seat $170
trunk lid $25
gas tank $50
brake set up ( steel braided line, billet lever) $125
Tank cover $40
VDO tach with stutter button set up( pingel slim line billet switch included) $300
Brand new pingle billet slim line dual switch $ 90
NOS pressure gauge $50
water temp gauge with modified upper thermostat house for sensor $55
Powermadd throttle block with lever $45
rear suspension with fresh hyfax and rail extensions. ( wheel were replaced last year and extra wheels added) $500
ripsaw 1.25 track with 268 studboy power points with tall nuts (less than 300 miles) $750
drive shaft $90
tunnel supports ( red)$30
snow cross snow flap( its huge) $35
mpem with tether $250
heat exchangers $175
running board trim ( red) $15
oil tank $35
water tank $20
front plastic belly pan $40
powermadd hand gaurds( red) $45
front heat exchanger $100 me with any offers or if you think a price is way out of line

trutildeathxxx@aol.com

bbqberky
10-28-2009, 08:03 AM
2004 skidoo rev, look at my pictures, everything else is good except the frame and tunnel, brand new motor with 15 minutes of run time, long track with under 300 miles on it. everything is aftermarket. tell me what you need


Interested in the front bumper of your ski-doo rev. Could you send photo and price ?