PDA

View Full Version : 91 Hatch Project For Sale



2KWK4U
02-01-2004, 04:44 PM
MOTOR
SVO 4 bolt block
Scat stroker crank
Dale Ernhardt Enterprises forged rods
JE 14:1 pistons
Comp Cams solid roller cam .820 intake .795 exhaust
Yates heads fully ported
Comp Cams valve springs
Jesel shaft mount rocker arms
Edelbrock high rise intake
Mezerie Electric water pump
MSD pro billet distributer
Kooks headers (step design 4" collector with muffler)
NOS Fogger kit jettet at 400HP
OVER $15,000 in motor alone, never run, similar setup with smaller cam and less compression pushed a little over 800HP NA

TRANS
Hipsters powerglide
Hipsters trans brake
Hipsters 5000rpm stall
Ultrabell
J&W "The Wheel" flexplate

CHASSIS
FRONT
Granatelli tubular k-member
Granatelli tubular control arms
Flaming River manual rack and pinion
manual brake conversion
QA1 fully threaded and adjustable struts

REAR
Comp. Engineering Ladder bars
Comp. Enginnering anti-roll bar
QA1 fully adjstable coilovers

8 Point cage with custom subframe connectors

Rear axle is an 8.8 is built and used Moser axles auburn spool, and I cant think of anything else.

Fuel pump is a Magnapump 500
Fuel cell is a Jaz, and has been recessed into the spare tire well.

Car comes with all the braided hoses, they just need to be cut and assebled.

Starter is also in the car, and most of the wiring is done, but must be completed.

A carb would need to be purchased, and well as a driveshaft, radiator, and shifter.

Front Welds are included, but no rears

Car has a 6" cowl induction Harwood hood.


I have over $24,000 invested, and it has the best of everything.
Price includes a 18' open car trailer.

$15,000 OBO or trades considered. Older Muscle cars, ATV etc.