PDA

View Full Version : machine shop


sloLs1
05-26-2008, 09:05 PM
im sure this has been mention before... but what machine shop do you guys recommend for a 4cyl motor... i need one of my saturn motors cleaned up bored honed and the works!



also need a place to knife edge the crank... then balance the rotating assembly:D
juicedimpss
05-27-2008, 04:51 PM
aer does nice block work. i havent used them for heads yet,but i would guess that would be good also.
sloLs1
05-27-2008, 06:51 PM
aer does nice block work. i havent used them for heads yet,but i would guess that would be good also.

what and where is that???


i have most of the head work already done so thats no biggy.... just need the block and crank checked out
modmachz
05-27-2008, 07:05 PM
[QUOTE=sloLs1;384539]what and where is that???


i have most of the head work already done so thats no biggy.... just need the block and crank checked out[/QUOTe.

www.engine-rebuilders.com
sloLs1
05-27-2008, 07:18 PM
^ thats funny i didnt know the abb. our shop has gone through those guys befor!
forest
05-28-2008, 10:49 AM
1522 arcadian ave waukesha wi, 53186? I believe is their exact address. Look for Donny, great guy and will take good care of you. 1-262-521-2250
HY35F2T
05-28-2008, 11:25 AM
yeah good place my buddy is getting his shit done there.
Trutildeathxxx
05-28-2008, 01:50 PM
forrest, i thought you would know the address by now, you have been out here enough. its 1604 arcadian ave, waukesha.
forest
05-28-2008, 02:43 PM
forrest, i thought you would know the address by now, you have been out here enough. its 1604 arcadian ave, waukesha.

haha yeah, I realized that a little bit ago.:goof
HY35F2T
05-28-2008, 03:17 PM
1522 arcadian ave waukesha wi, 53186? I believe is their exact address. Look for Donny, great guy and will take good care of you. 1-262-521-2250

Isnt that Aldi's address ?:goof:alcoholic
forest
05-28-2008, 04:33 PM
haha I think so
Russ Jerome
05-28-2008, 10:33 PM
I've been using C&S in Butler for several years now (used to use
AER with fine results). C & S has bored for my custom forged
slugs, decked my 8v and 16v heads, valve work ect. I have
inside bore gauges and Starret MICs and they have been spot
on every time.

http://www.cs-performance.net/

I just picked up my race head I had decked at C&S, they
noticed a custom mod I made was too shallow in the deck
and swapped it for deeper plug. Dropped off tue and picked
up today, ahead of schedule and better than I needed.
Syclone0044
05-29-2008, 01:56 AM
http://www.cs-performance.net/

I just picked up my race head I had decked at C&S, they
noticed a custom mod I made was too shallow in the deck
and swapped it for deeper plug. Dropped off tue and picked
up today, ahead of schedule and better than I needed.

Yeah another satisfied C&S customer here, seems like a real "no bullshit" shop to deal with. I'm real picky but haven't had any complaints so far. I tell em what I need and they do exactly that.:thumbsup