WTB sbc intake mani

[sloLs1]

looking for a edlebrock RPM air gap manifold.... or something close to that....

and possibly a set of heads....



and i hate to say it but the cheaper the better:headbang

[Memphis]

I've got a wieand single plane and a performer I believe...either one work?

[WickedSix]

got an air gap and a set of s/r torquer er something like that sitting on a 383...what you lookin to spend?

[sloLs1]

got an air gap and a set of s/r torquer er something like that sitting on a 383...what you lookin to spend?

well for an intake... im not sure you can buy a new one for $200...


as far as heads... i geuss it depends on what they are but i dont have more than $1000 to spend.

[sloLs1]

I've got a wieand single plane and a performer I believe...either one work?

i have a performer... i would like an air gap rpm looking for something good till 6.5krpms so a single plane might be alittle too much.

[WickedSix]

well for an intake... im not sure you can buy a new one for $200...


as far as heads... i geuss it depends on what they are but i dont have more than $1000 to spend.

i'll dig up the build sheet and get back to ya..I don't think they were ne thing fancy just bigger valves, bigger springs etc.... they seem a little anemic on the 383 but a smaller cube probably would be ok

[sloLs1]

i'll dig up the build sheet and get back to ya..I don't think they were ne thing fancy just bigger valves, bigger springs etc.... they seem a little anemic on the 383 but a smaller cube probably would be ok

a build sheet would be nice! i am looking for some specific stuff so that will definatly help!

[juicedimpss]

i have a performer... i would like an air gap rpm looking for something good till 6.5krpms so a single plane might be alittle too much.

single plane would work great in the saturn IMO

[sloLs1]

single plane would work great in the saturn IMO

well yes and no... if i go with a set of heads that can handle/flow a healthy cam well then yea.... but untill then no