View Full Version : WTB sbc intake mani
sloLs1
04-29-2008, 09:17 PM
looking for a edlebrock RPM air gap manifold.... or something close to that....
and possibly a set of heads....
and i hate to say it but the cheaper the better:headbang
Memphis
04-29-2008, 09:23 PM
I've got a wieand single plane and a performer I believe...either one work?
WickedSix
04-29-2008, 09:23 PM
got an air gap and a set of s/r torquer er something like that sitting on a 383...what you lookin to spend?
sloLs1
04-29-2008, 09:44 PM
got an air gap and a set of s/r torquer er something like that sitting on a 383...what you lookin to spend?
well for an intake... im not sure you can buy a new one for $200...
as far as heads... i geuss it depends on what they are but i dont have more than $1000 to spend.
sloLs1
04-29-2008, 09:45 PM
I've got a wieand single plane and a performer I believe...either one work?
i have a performer... i would like an air gap rpm looking for something good till 6.5krpms so a single plane might be alittle too much.
WickedSix
04-29-2008, 09:50 PM
well for an intake... im not sure you can buy a new one for $200...
as far as heads... i geuss it depends on what they are but i dont have more than $1000 to spend.
i'll dig up the build sheet and get back to ya..I don't think they were ne thing fancy just bigger valves, bigger springs etc.... they seem a little anemic on the 383 but a smaller cube probably would be ok
sloLs1
04-29-2008, 09:54 PM
i'll dig up the build sheet and get back to ya..I don't think they were ne thing fancy just bigger valves, bigger springs etc.... they seem a little anemic on the 383 but a smaller cube probably would be ok
a build sheet would be nice! i am looking for some specific stuff so that will definatly help!
juicedimpss
04-29-2008, 11:21 PM
i have a performer... i would like an air gap rpm looking for something good till 6.5krpms so a single plane might be alittle too much.
single plane would work great in the saturn IMO
sloLs1
04-30-2008, 10:21 PM
single plane would work great in the saturn IMO
well yes and no... if i go with a set of heads that can handle/flow a healthy cam well then yea.... but untill then no
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.