Can anyone fiberglass or lay carbon fiber?

[Poncho]

If so, and depending on cost, I need you to make me a car part that a raccoon decided to rip off my car last night @ 75mph.

I still have the part, but nearly all it's mounting points are damaged, and it's scraped to hell from the road. But a mold could easily be made of it.

Either of those (particularily the mounting points) should hold up better than the crap on it now.

[DurtyKurty]

Is this a custom part? Because it's not likely that the cost of an OEM part is going to out way the cost of a custom layup.

Size? Picture?

[Poncho]

the grey lower piece
http://i251.photobucket.com/albums/gg311/fastpacedgtp/05GTO/gto131.jpg?t=1205980794

new cost is over $200 AUD.

i figure someone good could take mine and use it to mod this one/make better

[DurtyKurty]

Yeah. You would have that much or more just in materials. It's quite labor intensive to boot.