Ram SRT10 Venom 1000 Twin Turbo

[CannotPost]

Had a few friendly runs with this truck. Wow..... very mean setup. Is the owner a member of BCM? Did anyone else see this truck on "that road" saturday nite? I think I saw it parked a Cluvers earlier in the evening.

[Lash]

lol...this will get good.

[Want_Notch]

I was at Culver all night and didn't see it.

Maybe it was parked in tool land

[BAD LS1]

Was it black? and a quad cab?

[CannotPost]

lol...this will get good.
Hu? did I say somthing wrong?


Yes it was a black quad cab! Very clean and shiny!

[BAD LS1]

Eh... auto... im not sure how long that will hold up... Would have a greater coolness factor to me if it was a 6 speed reg cab...

[CannotPost]

It sure was an auto.. For a 4 door 5400# pickup it moved... like a freight-train. The owner was nice and stopped to chat, I guess he bought it built already.

[Flicktitty]

yeah i saw the truck pull into the culvers and park, it looked "stockish" to me, and it didn't seem too special when it was driving i'll have to look at it better next time.

[CannotPost]

yeah i saw the truck pull into the culvers and park, it looked "stockish" to me, and it didn't seem too special when it was driving i'll have to look at it better next time.

It was stock on the exterior... It did have Venom 1000 badges, I think the owner said it had twin t67's? On the 1000 hp tune it makes 1200 ft.lb's of torque. So yea kinda special

[Brandon W.]

So yea kinda special


like stop eating the glue special?:goof

sounds like a cool truck..to bad i wasnt at culvers to see it.

[CannotPost]

like stop eating the glue special?:goof

sounds like a cool truck..to bad i wasnt at culvers to see it.


It is big and could be considered a "short bus":)

[stowsea]

It was stock on the exterior... It did have Venom 1000 badges, I think the owner said it had twin t67's? On the 1000 hp tune it makes 1200 ft.lb's of torque. So yea kinda special

dam! sounds cool!

[BAD LS1]

HTF does a stock mopar auto hold up behind that motor? MAYBE if its like the same one out of a diesel 1-ton... It prolly aint no 40RFE or whatever lol it aint no torqueflight or nothing... thats for sure!

[CannotPost]

HTF does a stock mopar auto hold up behind that motor? MAYBE if its like the same one out of a diesel 1-ton... It prolly aint no 40RFE or whatever lol it aint no torqueflight or nothing... thats for sure!

It is probably not stock, when you go to Hennessey’s website it looks like the engine and Trans are built.

[BAD LS1]

Yeah idk... thats more output than most of the hottest street driven cummins's can put out... Prolly only has a 10 WOT run warranty... when the tranny falls out of the truck on the 11th run, too bad so sorry hahahaha

[CannotPost]

Yeah idk... thats more output than most of the hottest street driven cummins's can put out... Prolly only has a 10 WOT run warranty... when the tranny falls out of the truck on the 11th run, too bad so sorry hahahaha

So it is more of a 36 thousand miles or 1 wot run whichever comes first type of warranty

[HRSEPLA]

I was parked next to it in the front lot with my Cobra, didnt get a chance to talk to him, but I noticed his plate said "955RWHP", we shall see......:)
Neat truck if its all true...

[CannotPost]

I was parked next to it in the front lot with my Cobra, didnt get a chance to talk to him, but I noticed his plate said "955RWHP", we shall see......:)
Neat truck if its all true...


Yup, thats the one. I saw under the hood it has this setup:

http://www.hennesseyperformance.com/hennesseyperformance/ItemDetail.php?Item_ID=177&cart=JirYpnjK&DoThis=Dodge+Ram+SRT10&ActionReq=Where

[Lash]

1,000 h.p/ 1200 ft.lbs. = 10.3's?

[Brandon W.]

1,000 h.p/ 1200 ft.lbs. = 10.3's?

you must remember....your not moving a 1 ton car..your moving a 7000lb~ truck

[Prince Valiant]

it aint no torqueflight or nothing... thats for sure!Actually, it is.

It's the 48RE, the tranny used on 2006 and prior diesels and v-10's prior to their discontinuation. The 48RE is essentially a 727 torqueflite with an overdive unit built into the tailshaft....

[Lash]

you must remember....your not moving a 1 ton car..your moving a 7000lb~ truck
Hennessey says 5300 lb's. I've seen other sites go from 5100lbs. (reg cab) to 5600lbs (quad cab).

[Brandon W.]

Hennessey says 5300 lb's. I've seen other sites go from 5100lbs. (reg cab) to 5600lbs (quad cab).


ok so im 1,400~ off..still thats alot of weight to get moving:headbang

[Al]

I bet that thing moves.

Is it 4wd?

[CannotPost]

I bet that thing moves.

Is it 4wd?

Negative --- RWD = Huge tire spin. It also has 20" inch or bigger rims and wide ass tires

[Prince Valiant]

Negative --- RWD = Huge tire spin. It also has 20" inch or bigger rims and wide ass tires
IIRC, they are 22" rims stock.

[CannotPost]

IIRC, they are 22" rims stock.

That sounds right, I think it was running stock rims.

[Lash]

From the Hennessy site...


Acceleration (with optional drag wheels/tires):

0-60: 3.1 sec.
1/4 mile: 10.3 sec. @ 133 mph

[CannotPost]

Check out this thread.... This is the truck, in fact it still has OK plates that read "955 rwhp"
http://www.srt10forum.com/forums/showthread.php?t=10223&highlight=Hennessy

http://i51.photobucket.com/albums/f367/K-80-123/DSC_0034.jpg
http://i51.photobucket.com/albums/f367/K-80-123/112-1219_IMG.jpg
http://i51.photobucket.com/albums/f367/K-80-123/112-1211_IMG.jpg

[Flicktitty]

****** thing is badass!

[CannotPost]

http://i51.photobucket.com/albums/f367/K-80-123/DynoGraphWalltsTruck.jpg

http://i51.photobucket.com/albums/f367/K-80-123/112-1203_IMG.jpg

http://i51.photobucket.com/albums/f367/K-80-123/111-1179_IMG.jpg

http://i51.photobucket.com/albums/f367/K-80-123/112-1218_IMG.jpg

[Breecher_7]

5600 pounds sounds a little heavy actually. My 1500 4x4 weighs 5,546 with a full tank of fuel. I put it on the truck scale at work.

[hrsp]

nice truck!!!

[Buster]

Check it out: http://media.putfile.com/RAM-SRT-QC-TT-1006-RWHP

[MARO-MAN]

That truck is awesome. They should put that set-up in the new Challenger!

[Moparjim]

Awesome truck, but Hennessy is a huge ripoff artist. Search the web and Viperalley and VCA forums for all the horror stories. Not to mention you can build the same trucks and Vipers for a FRACTION of what he charges. He wants like $225,000 for a Venom 800, my 875 HP cost me under $10K to do. Paulo Castellano makes a 1400 HP TT kit for $20K. Even if somebody wants it turnkey there are numerous other much more reasonablely priced Viper tuners like Heffners Performance.

[CannotPost]

Awesome truck, but Hennessy is a huge ripoff artist. Search the web and Viperalley and VCA forums for all the horror stories. Not to mention you can build the same trucks and Vipers for a FRACTION of what he charges. He wants like $225,000 for a Venom 800, my 875 HP cost me under $10K to do. Paulo Castellano makes a 1400 HP TT kit for $20K. Even if somebody wants it turnkey there are numerous other much more reasonablely priced Viper tuners like Heffners Performance.

Woah!!!!........... I wonder what in invested in this truck???

[Moparjim]

Well the price on the website says "Call for price" you know what that means... Usually it means "So much I am ashamed to print it and don't want to shock and scare you off without a chance of selling you on it and sweet talking you first". My best guesstimate is since the Viper new is around $90K of that $220K price range so Hennessy's package/markup on the Viper Venom 800 is around $130K it would seem. The truck goes for much less around $40-45 I think new, and I bet the markup he can get away with is much lower on the truck but its also a built motor and more HP so even if you go half the $130K its still over 6 figures maybe more...

[CannotPost]

Well the price on the website says "Call for price" you know what that means... Usually it means "So much I am ashamed to print it and don't want to shock and scare you off without a chance of selling you on it and sweet talking you first". My best guesstimate is since the Viper new is around $90K of that $220K price range so Hennessy's package/markup on the Viper Venom 800 is around $130K it would seem. The truck goes for much less around $40-45 I think new, and I bet the markup he can get away with is much lower on the truck but its also a built motor and more HP so even if you go half the $130K its still over 6 figures maybe more...

Wow, I did not know it was that expensive! Seems you can get the same thing for 1/8th the price with a homebrew route.