Getting a clutch need anything else?

[lilws6]

i'm hopefully selling my integra today and i'll be ordering my ls7 clutch kit. Is there anything else i should get? Bearings, bolts? anything i can't think of right now? the car has 60,000 miles on it. some one said slave and master but its a 2001 it shouldn't need a new anything should it?

[BAD LS1]

The hyraulics could use a good flushing, I.e. everything should come off and get cleaned out of the old nasty brake fluid. ONLY USE DOT3 BRAKE FLUID, NO SILICONE!!!!

Make sure to get a clutch alignment tool too. Gonna need a gallon of dexronIII ATF for the tranny too.

[sloLs1]

well if you dont get a "clutch kit" i would recommend a throw out bearing and a piolet(sp?) bearing. are you using your factory flywheel???

[Poncho]

In case you didn't know, you'll need an LS2 vette flywheel, then you can use the LS7 clutch & LS7 pressure plate.

Funny, I'll be upgrading to the LS7 when my LS2 clutch gives up.

stock LS2 clutch v.s. LS7 clutch:
http://www.ls1gto.com/pictures/LS2GTODisc.jpg
http://www.ls1gto.com/pictures/LS7Disc.jpg

[Poncho]

P/n 12571611, Flywheel, LS2/LS7:
------------------------------------
Suggested List - 272.99

PART # 24237690 Press Plt/disc, LS7:
------------------------------------
Suggested List - 457.86
------------------------------------
Part # 11516862 Pressure Plate Bolts

[sloLs1]

^^^ wow big difference in friction material!!!



and +1 for the good info! should be made a sticky!!!

[Poncho]

just remember....


I'm Ghey, and i'm a useless idiot.

[lilws6]

the kit is the clutch and ls2 flywheel got that taken care of and you say i should get both bearings?