View Full Version : Looking for sheet metal help!
SSDude
02-27-2007, 09:16 PM
I know there are a few guys out there that work in the trades. Do any of you HVAC guys know where i can get galvanized spiral duct pipe? I have a venting project to do at work and i'm not sure were to get the supplies. We're located near the airport if there any supply houses near there.
Thanks:thumbsup
SSDude
Korndogg
02-27-2007, 09:17 PM
did you try Grainger??
What size do you need and how much? What are you venting?
You can get it from 'Milwaukee Insulation' in Butler. They'll deliver it.
262-790-2000
You can also try 'Forced Air Products' in New Berlin...... 262-782-2434. Milwaukee insulation has better quality though.
Korndogg
02-27-2007, 09:28 PM
Damn tinners.
SSDude
02-27-2007, 09:41 PM
Grainger didn't have anything.
We need to vent a conveyor oven. It has a 2" vent outlet on each end that will be tee'd into one 4" drop.
SSDude
02-27-2007, 09:42 PM
Regular stove pipe isn't durable enough
SSDude
02-27-2007, 09:44 PM
What size do you need and how much? What are you venting?
You can get it from 'Milwaukee Insulation' in Butler. They'll deliver it.
262-790-2000
You can also try 'Forced Air Products' in New Berlin...... 262-782-2434. Milwaukee insulation has better quality though.
Thanks Lash:thumbsup :thumbsup
2" spiral might be a special order (might take a few days to get). I'm not even sure they make 2". 3" might be as small as it goes. You might just have to use regular snap-lock pipe (the stuff that snaps together).
How hot is this vent gonna get?
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.