pOrk
02-12-2007, 11:09 PM
Started with the GPS, the mount, and a bicycle clamp for a headlight.
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/gps1.jpg
I cut off this small bracket thing that was on it ( right hand side of this photo, already gone ) so it would be flat enough to mount the GPS bracket to it.
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/gps2.jpg
Then I used piece of bicycle inner tube to wrap around the mirror stay to get the diameter I needed for the clamp, and clamped it up. The GPS pops in and out, real easy.
Now the rear view camera monitor I bought came with a ridiculously un-usable mount, so I made my own. It is pictured on the right hand side of this photo, along with the mount I made and the monitor itself.
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount.jpg
Back of the mount:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount2.jpg
Drilled some holes through the bottom of the mount and the plastic bar, then tapped them with a #7 since 6 was no where to be found:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount3.jpg
All finished:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/everythingdone.jpg
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/gps1.jpg
I cut off this small bracket thing that was on it ( right hand side of this photo, already gone ) so it would be flat enough to mount the GPS bracket to it.
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/gps2.jpg
Then I used piece of bicycle inner tube to wrap around the mirror stay to get the diameter I needed for the clamp, and clamped it up. The GPS pops in and out, real easy.
Now the rear view camera monitor I bought came with a ridiculously un-usable mount, so I made my own. It is pictured on the right hand side of this photo, along with the mount I made and the monitor itself.
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount.jpg
Back of the mount:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount2.jpg
Drilled some holes through the bottom of the mount and the plastic bar, then tapped them with a #7 since 6 was no where to be found:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/rearviewmount3.jpg
All finished:
http://i142.photobucket.com/albums/r87/thegreenpOrk/TL1000R/everythingdone.jpg