Adamsy87
11-29-2006, 11:16 PM
Complete 3" true dual exhaust w/ coated Hooker long tube headers
-1/2 round tube and 1/2 oval tube (Round tube from collector to H-pipe, oval from H-pipe to dumps to provide adequate ground clearance)
-Oval tubes and mufflers are "SpinTech" brand (Mufflers are only 3" thick)
-Made to fit around Spohn aftermarket torque arm and crossmember
-Hooker 2210 long tube headers have 1 3/4" primaries w/ 3" collectors and have welded bung on driver's side for oxygen sensor
-Pipes dump in front of rear axle, dumps are slanted towards eachother to deflect sound
The complete system has been used for a year and half. I have well over $1350 into this system. The fabrication work was done by fellow board member: TopfuelTom @ otedesign.com
I'm looking for $900 for it.
I can get pics of it if needed.
-1/2 round tube and 1/2 oval tube (Round tube from collector to H-pipe, oval from H-pipe to dumps to provide adequate ground clearance)
-Oval tubes and mufflers are "SpinTech" brand (Mufflers are only 3" thick)
-Made to fit around Spohn aftermarket torque arm and crossmember
-Hooker 2210 long tube headers have 1 3/4" primaries w/ 3" collectors and have welded bung on driver's side for oxygen sensor
-Pipes dump in front of rear axle, dumps are slanted towards eachother to deflect sound
The complete system has been used for a year and half. I have well over $1350 into this system. The fabrication work was done by fellow board member: TopfuelTom @ otedesign.com
I'm looking for $900 for it.
I can get pics of it if needed.