3rd Gen Camaro Complete True Dual Exhaust

[Adamsy87]

Complete 3" true dual exhaust w/ coated Hooker long tube headers
-1/2 round tube and 1/2 oval tube (Round tube from collector to H-pipe, oval from H-pipe to dumps to provide adequate ground clearance)
-Oval tubes and mufflers are "SpinTech" brand (Mufflers are only 3" thick)
-Made to fit around Spohn aftermarket torque arm and crossmember
-Hooker 2210 long tube headers have 1 3/4" primaries w/ 3" collectors and have welded bung on driver's side for oxygen sensor
-Pipes dump in front of rear axle, dumps are slanted towards eachother to deflect sound

The complete system has been used for a year and half. I have well over $1350 into this system. The fabrication work was done by fellow board member: TopfuelTom @ otedesign.com

I'm looking for $900 for it.
I can get pics of it if needed.

[PonyKiller87]

If you dont have any luck selling it as a complete set I may be interested in just the headers,


Do you have a picture of the system?

[Adamsy87]

I can definitely get some pics for you by friday or sat. I would probably be willing to sell the headers separately for $300.

[Poncho]

dual 3"?? i'd be interested but thats mega overkill.

[FourEyedFord]

dual 3"?? i'd be interested but thats mega overkill.

Yes it is. I have seen it personally, and it is a great looking setup. :thumbsup

[Adamsy87]

unfortunately because of the weather I was not able to get out to the shop to take pictures. I will get them as soon as possible

[Poncho]

if it were like 2 1/4" or so I'd be all over that.