Dana S60

[A B4C Z]

Well I went and picked up my rear end 2 weeks ago from strange along with a driveshaft from them. I brought it home and painted it. Got it in last weekend and was out and about with it friday. Took a few shots of it. Let the flamin begin!:banana1:
http://i38.photobucket.com/albums/e143/97ZMeGo/DSC03916.jpg

Kyle

[sloLs1]

looks good!!! car looks very clean as well!

[TransAm12sec]

Your car is clean.

[Crawlin]

Your car is slow.


easy now!!! ;)

[Knyghtmare]

Lookin good. :thumbsup

[dr doom]

wow, looks really good!

[HP ADDICT]

I got one of those to. Is that the upgraded cover?

[0TransAm0]

damn do you eat off the underside of your car?? looks good and clean. :)

[A B4C Z]

Thanks for the replys. Doesnt see the weather. And i usally wipe it off every oil change(so about every 1000 miles) plus when im board at home here. Yup thats the 60.00 upgraded cover. It fits perfect, I have a few shots of the clearnce on the panhard rod ill try and get up. Everything bolted right up no issues. Just whines like a *****. Not sure if its because of the New torque arm helping transmit the sound. Definetly a nice peice of equipment. Grease fittings on the axles. The clips for the brake lines. And the stock e brake cable brackets bolt right up to the thing. Couldnt of asked for a better fit.

Kyle

[USMARINE1108]

Looks good. What gears are in it?

[A B4C Z]

I got 4:11s. Its a blast to drive now. I hava a pretty stout cam and only had 342s. Its a whole differnt car to drive now. Im loving it.

[BadAzzGTA89]

I also have to say how clean it is!!! Keep it up!!!!!

[FourEyedFord]

That is a BEAST of a rear end! :rolf

Just kiddin', looks awesome Kyle!

[Slow Joe]

Wow, nice... And I'll have to agree with everyone else... that car is CLEAN! I wish my Stang were that clean... Blah screw Wisconsin winters :rolf

[WilliamZ]

Looks good Kyle!!

[97z2801ss]

Looks good kyle!!
damn its clean under there!
Good job!

[number1]

Nice. What TQ arm is that?

[A B4C Z]

Thanks for the compliments. Its the Sphon ADJ. With the poly mount and drive shaft safety loop. That is the one that offers the most clearance also. Between the exhaust and the cross brace there is about a inch almost of clearence.

[Prince Valiant]

Weird seeing a Dana with coil springs. Looks good...I'd think it whines just because you've got stronger harder gears that are naturaully louder.

looks great...

[H8RADE]

Just whines like a *****. Not sure if its because of the New torque arm helping transmit the sound.

Don't go over 50 mph during break in, and only drive 15 minutes or so at a time before letting it cool down.
Do this the first couple hundred miles and change the fluid after the first 500 miles and you are good.
I have bought more than a couple of axles from Strange and the 'run in' the gears.
'Break in' is for the buyer, and needs to be done under load.
If you go over 50 during break in, the whine may never go away.
HTH.

[SLONOMA]

damn that car is dirty... nice paint on the muffler:rolf

[BAD LS1]

LOL i noticed that too, the rest is nice, but the muffler paint is jacked. Your slackin Kyle!

Yeah that is one BEAST of a rear! i have personally seen this one going down the road with my own two eyes though! Maybe could hear it too... lol j/k

[A B4C Z]

I will be seeing track time next week. Im going for some low 12s this year! Jeffs going to teach me how to drive:rolf

[GTSLOW]

Wow really nice setup! :wooo

So whats the differences to this compared to a 12bolt? Cost/strength/weight?

[A B4C Z]

Cost it was Cheaper. Stregth (holds breath) its sposed to be stronger. Weight is 9 pounds heavier than a 9 inch and 17 than a 12 bolt(dont quote me but its very close to those).

[GTSLOW]

Ah sounds like a nice alternative to a 12bolt.

If you dont mind me asking how much did it run? Also were you able to swap your stock brakes over to it without any conversion stuff?

[Cryptic]

http://i38.photobucket.com/albums/e143/97ZMeGo/DSC03916.jpg



:drool:

[1quickgtp]

nice that is tits. now go drive the thing an get it dirty so you dont make us all look like schmucks for not having a clean car like you do!

[A B4C Z]

Got it from speed inc on a GP. It was 2052.99 + 65.00 for that cover on it. Then you need a new drive shaft. I got it for 259.99 Chromoly. I went and picked it up and saved on shipping. Shipping can be anywere from 150-250. Most were comming in around 170 bucks i guess. But some were outragous. Strange is only 1 hour and 30 mins away. About 30-40 mins from great america and its a strait shot and right off the freeway.

You will also need backing plates for ls1 cars becuase there pressed on. Those were 153.32 Brand new with tax. So about 2500 bucks and its all ready to literaly bolt right in when you get it. Everything fit super and as you can see there isnt much left stock back there.

Its going for some abuse on tuesday as long as it doesnt rain!!!!!
Kyle